Everyone loves our MTN-10 and ODR-10 pedals – the most authentic and accurate clones of the Ibanez MT-10 and Nobels ODR-1 out there.
Many have discovered the magic in stacking them. Machine Shop goes beyond that.
After a year of development we are proud to present the Karma Machine Shop!
- ODR & MTN circuits – Stacked (series) or Blended (parallel)
- STACK mode – choose the order of the circuits
- BLEND mode – circuits are mixed together for ultimate flexibility
- Dry signal – mix in part of your clean sound (BLEND mode with either side bypassed
- HOLD FOR BOOST function with variable gain control
- Pure analog audio signal path and true bypass
- Programmable power-up
ODR Side
- Drive – amount of overdrive
- Level – output level of ODR circuit
- Spectre – tone control
- ODR Footswitch – True bypass when off
Back panel top left to right
- Output jack – to amp or other pedals
- 9-18V DC – Power jack, center negative (Boss style)
- Input jack – instrument plugs in here
- BOOST VOL – controls the amount of output boost applied when Master Bypass/Hold for Boost footswitch is activated
Master Bypass/Hold For Boost
- Click for Master Bypass of entire pedal
- Hold briefly to engage overall output boost
- Boost level set by Boost Vol control upper right
- Master (orange) LED will blink on/off
- Boost can be active even with pedal bypassed (LED will blink dimly)
MTN Side
- Drive – amount of overdrive
- Vol – output level of MTN circuit
- B/M/T – Bass/Mids/Treble controls
- MTN Footswitch – True bypass when off
Setting the Power-Up State
- Set the on/off state of all foot switches on power-up:
- With power applied, hold down both ODR and MTN foot switches until LEDs blink
- Set on/off state of ODR/MTN/Master Bypass to your preference
- Hold down both ODR and MTN foot switches to exit programming mode.
STACK MODE:
- Pedal circuits in series, one after the other
- The lower STACK ORDER switch sets which pedal is 1st in the stack
- Set the upper slide switch to the left
BLEND MODE:
- Input goes equally to both circuits, mixed together in a ratio determined by the BLEND control.
- Turn to the left for more ODR, to the right for MTN.
- The (upper) BLEND switch is set to the right.
- The STACK ORDER switch is out of the circuit.
